Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

%IP-3-LOOPPAK: Looping packet detected and dropped

Hi

I am getting an error msg on my core (3750) IPB through the CNA repeated.

X-Mailer: Cisco Network Assistant System Messages Notification Mailer

Device: CGCCORESW01

005773: *Mar  8 05:19:54: %IP-3-LOOPPAK: Looping packet detected and dropped

-

Can anyone suggest me what should i do to resolve the problem.

Thanks and Regards

Saurav Tripathy

2 REPLIES
Bronze

Re: %IP-3-LOOPPAK: Looping packet detected and dropped

Saurav,

     This error is usually seen when you have the ip helper address incorrectly. Make sure that you have the address of the dhcp server configured correctly and not the ip address of the local device itself.

New Member

Re: %IP-3-LOOPPAK: Looping packet detected and dropped

Hey..

     There is some misconfiguration of an IP helper address. The helper address should be the same address as that of the server of the intended service. Putting the address of the router in the helper address causes a routing loop to be created.

You have to verify that the configuration of the IP helper addresses in the router correctly that points to the right device and does not point to the local router itself.

hope this helps

Regards,

Srinadh.

2522
Views
0
Helpful
2
Replies
CreatePlease to create content