Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP-4-CLASS: Bad IP address and mask 0.0.0.0/32 in class_resolve()

Hi..

I just telnet to a router and having an error message:

IP-4-CLASS: Bad IP address and mask0.0.0.0/32 in class_resolve()

How to clear that message?

Thanks....

1 REPLY
Gold

IP-4-CLASS: Bad IP address and mask 0.0.0.0/32 in class_resolve(

hi,

is it the only error you get or followed by BOOTP err. ?

this error usualy happens when u havent set an ip address on a device and its is trying to get an IP from DHCP, without a success... followed by a BOOTP err line. hmmm...

could u post ur router config here?

plz Rate if it helped.

Soroush.

Hope it Helps, Soroush.
1266
Views
0
Helpful
1
Replies