10-08-2013 02:04 AM - edited 03-07-2019 03:54 PM
hi all ,
Is ip accouting is supported on the cisco 3750 swiitch? coz i m not getting any output in show ip accouting command .
Thanks!
Regards,
Vijay
Solved! Go to Solution.
10-08-2013 06:32 AM
HI Vijay,
as per this document:
Unsupported Commands in Cisco IOS Release 12.2(53)SE2
this command is not supported .
you can see the all commands which are not supported on your catalyst..
Regards
Hope it helps.
10-08-2013 02:23 AM
hi vijay,
i believe it's unsupported.
10-08-2013 05:57 AM
It does work on my 3750 running ip services IOS
3750-switch#sh run int fa 1/0/1
Building configuration...
Current configuration : 175 bytes
!
interface FastEthernet1/0/1
no switchport
ip address #.#.#.# #.#.#.#
ip accounting output-packets
speed 100
duplex full
end
3750-switch#sh ip account
Source Destination Packets Bytes
#.#.#.# #.#.#.# 151 12684
#.#.#.# #.#.#.# 9 709
#.#.#.# #.#.#.# 9 1260
#.#.#.# #.#.#.# 10 1407
Accounting data age is 3
10-08-2013 06:09 AM
Hi Serge Amos ,
Could u plz tell the model of the switch and version of IOS ??
10-08-2013 06:17 AM
cisco WS-C3750-48TS
c3750-ipservices-mz.122-50.SE1.bin
10-08-2013 06:11 AM
HI Vijay ,
Whcih version of IOS u r running on catalyst
ip accounting
ip load-sharing [per-packet]
ip mtu bytes
ip verify
ip unnumbered type number
All ip security commands
Regards
Hope it helps.
10-08-2013 06:18 AM
Hi sandeep ,
I am using
:c3750-ipservicesk9-mz.122-53.SE2.bin
10-08-2013 06:32 AM
HI Vijay,
as per this document:
Unsupported Commands in Cisco IOS Release 12.2(53)SE2
this command is not supported .
you can see the all commands which are not supported on your catalyst..
Regards
Hope it helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: