I need some help on IP camera network I am currently Installing. The project consists of following
1) 22 vivotek camera model IP8332C/FD8134/FE8174 2) 1 QNAP NVR with 48 TB hard disk space of raid 5 3) Cisco catalyst series POE switch 10/100/1000 Model CISCO CATLTSY 2960 / 3560 4) Fiber up link between switch 5) VLAN network created between switch
I have set all the camera to 4-6 Mbps bandwidth and FE8174 to 12 Mbps, the theoretical maximum bandwidth consumption is about 200 Mbps. The VLAN network was created by the customer engineers as per them they have not put any special restriction on the LAN.
The problem is that I am getting much buffering on the video which per my logic i should not get any, it seems that the VLAN is getting less bandwidth than required,
Is there any special setting is required on the switch? As per the engineer no priority setting has been done and only a VLAN has been created on the switches. The switches are being shared with client network.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.