09-25-2017 01:28 PM - edited 03-08-2019 12:09 PM
I tried to issue command ip flow monitor ..... output on a trunk interface on switch 2960x, but it errrored out with could not be added to interface due to invalid sub-traffic type: 0. We have a Cisco One license and running on c2960x-universalk9-mz.152-5.E2.bin. Does anyone experience with this error and how to fix it? or the switch just doesn't support the output? Thanks all.
Solved! Go to Solution.
09-28-2017 04:38 PM
This link refers to 4500 series but the same limitation may also may apply to the 2960x series
https://www.lancope.com/wiki/cisco-catalyst-4500x
HTH
09-26-2017 12:53 AM
Hi
you tried to add ip flow a layer 3 command to a layer 2 trunk port , it needs to be added to the vlan svi interface on a latyer 2 switch or else use the
As well if your trying to collect layer 2 fields make sure the specific mac fields are in place
09-28-2017 01:32 PM
Thanks. Basically the output command can't be issue on a interface alone.
09-28-2017 04:38 PM
This link refers to 4500 series but the same limitation may also may apply to the 2960x series
https://www.lancope.com/wiki/cisco-catalyst-4500x
HTH
02-13-2019 01:00 AM
This link is not function :-( i have similar problem on C2960X IOS 15.2.4.E7
02-13-2019 01:03 AM
Whats the problem your having ?
03-31-2019 01:18 AM
% Flow Monitor: 'MonitorTest' could not be added to interface due to invalid sub-traffic type: 0
spoken about 2960X switches. I have same problem that explained above
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide