Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ip helper-address

Hi All,

I have a vlan interface with secondary ip address configured.

vlan 10

ip address

ip address secondary

ip helper-address

I have confgured my DHCP for both & network.

How the IP address will be distributed among with vlan 10 users. DHCP pool will allocate first from network and then from

Or it will allocate from the primary address of the interface?

How can I handle this situation?



New Member

Re: ip helper-address

This depends on your DHCP server. I haven't read the RFC recently, but I do not believe that it is defined. I have run two different DHCP servers and have always had to tell the server if a physical interface had multiple logical networks (shared-network) associated with it, but at least from memory, have only had a pool(s) associated with one of the logical networks. In some cases, I do have multiple pools associated with an interface (though, all on the same logical network) and my server tends to rotate through all the addresses from least to greatest before wrapping around again. I would assume that if I had multiple pools on different logical networks that it would do the same thing.

New Member

Re: ip helper-address

Take a look at the dhcp smart-relay feature - it might just do what you want.

"[...]you only need the ip dhcp smart-relay command configured if you have secondary addresses on that interface and you want the router to step through each IP network when forwarding DHCP requests. Without the smart relay agent configured, all requests are forwarded using the primary IP address on the interface."

New Member

Re: ip helper-address

Thank you.

CreatePlease login to create content