I understand that the Catalyst 3560 supports basic IP routing by default. We would like to use the switch for inter-VLAN routing, however, our configuration requires the use of the IP Helper command to forward broadcast packets to a DHCP server located on a different VLAN than the clients. Do we require Advanced IP routing functionality in order to use the IP Helper command on the Catalyst switch? If so, do we need to perform a firmware upgrade or purchase another license to obtain this functionality?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...