cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1691
Views
0
Helpful
1
Replies

ip nbar port-map

simaskvilius
Level 1
Level 1

I'm wondering what purpose of port mapping in nBAR, how and when it is used during packet inspection. Why port maches are needed when deep packet inspection is done anyway.

For example, if I'm accessing web page with port 666 (http://www.example.org:666) and my port-map is left in default state how those http packets will be clasified by nbar?

1 Accepted Solution

Accepted Solutions

nikolasgeyer
Level 1
Level 1

Port mapping with NBAR is usually done to add support for protocols that are not currently supported by a match protocol statement. It extends the ability of NBAR to match any custom traffic you want matched that NBAR currently does not support.

There is a detailed page of NBAR port mapping and PDLM's at http://www.cisco.com/warp/public/105/custompdlms.html

Hope this helps.

Nik

View solution in original post

1 Reply 1

nikolasgeyer
Level 1
Level 1

Port mapping with NBAR is usually done to add support for protocols that are not currently supported by a match protocol statement. It extends the ability of NBAR to match any custom traffic you want matched that NBAR currently does not support.

There is a detailed page of NBAR port mapping and PDLM's at http://www.cisco.com/warp/public/105/custompdlms.html

Hope this helps.

Nik

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: