Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ip network (Vlan)

hello1

i have 4 layer 3 interface;

int vlan 100(ip:1.1.100.1)

int vlan 101(ip:1.1.101.1)

int vlan 102.(ip:1.1.102.1)

i have to enable ipx network on these vlans.

do i need to assigne different network numberes to these vlan or the same for these 3 vlans ?e,g:

ipx routing

for vlan 100:

int vlan 100

ipx network 100 encapsulation SAP

for vlan 101

int vlan 101

ipx network 101 encapsulation SAP

for vlan 102

int vlan 102

ipx network 102 encapsulation SAP

many thannks

10 REPLIES
Hall of Fame Super Blue

Re: ip network (Vlan)

Ali

You should have no problem with this configuration as you can use the vlan numbers as your IPX network numbers if that is what you want.

Jon

New Member

Re: ip network (Vlan)

hello jon!

if i use IPX network 100 for these 3 vlans.does it work

10xs for ur support in this great forum

Ali

New Member

Re: ip network (Vlan)

BTW how these commands work for ipx in L3 Intefaces:

vlan 101

ipx network 110 encapsulation SAP

vlan 100

ipx network 5

ipx network 100 encapsulation SAP secondary

Hall of Fame Super Bronze

Re: ip network (Vlan)

When assigning network numbers to interfaces that support multiple networks, you can also configure primary and secondary networks.

The first logical network you configure on an interface is considered the primary network. Any additional networks are considered secondary networks. Again, each network on an interface must use a distinct encapsulation and it should match that of the clients and servers using the same network number.

New Member

Re: ip network (Vlan)

hello Edisson!

10xs for ur reply.plz provide me a link regarding our situation.do i need to configure the network numbere on the servers/clients also?

10xs

Hall of Fame Super Bronze

Re: ip network (Vlan)

The answer depend upon the IPX stack running on those devices.

WindowsXP auto-detects the LAN IPX Network as well as the IPX Frame-Type if running 802.2. I've seen issues auto-detecting 802.3.

As for the servers, same as the clients, it depends. Are you talking about NetWare servers or other OSes ?

New Member

Re: ip network (Vlan)

Hello Edisson!

yes we have Netware Server1

10xs

Hall of Fame Super Bronze

Re: ip network (Vlan)

You need to bind the LAN IPX Number and Frame-Type manually.

It's been a while since I dealt with NetWare but if I recall, the command is LOAD INETCFG and follow the prompts.

Hall of Fame Super Blue

Re: ip network (Vlan)

Ali

No you can't use the same IPX network number on the 3 vlans because they are separate vlans. You need to stick with your original addressing scheme and make sure you enable "ipx routing".

Not sure about the "secondary" statement in your other question, perhaps someone else could explain.

Jon

New Member

Re: ip network (Vlan)

10xs jon

134
Views
25
Helpful
10
Replies