10-21-2013 04:08 AM - edited 03-07-2019 04:08 PM
Hi,
I tried to apply the ip policy route-map command to an interface vlan X, but is not working.
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 30 WS-C3750X-24 15.0(2)SE1 C3750E-UNIVERSALK9-M
2 30 WS-C3750X-24 15.0(2)SE1 C3750E-UNIVERSALK9-M
10-21-2013 04:38 AM
Hi,
1° make sure you've got the IP services image installed on the master with show licence
2° show sdm prefer and change your SDM template to sdm prefer routing if needed then reload and verify with show sdm prefer again.
Regards
Alain
Don't forget to rate helpful posts.
10-21-2013 06:20 AM
In addition to the good points that Alain makes I would ask that you provide some details of how you have configured Policy Based Routing. One common mistake is to apply the route map on the exit interface when that is required is to apply the route map on the interface on which traffic arrives. So if we can see what you have configured we can determine whether it is an issue like that.
HTH
Rick
10-21-2013 06:55 AM
Hi all,
HOSTKJ1#sh license
Index 1 Feature: ipservices
Period left: 8 weeks 4 days
License Type: Evaluation
License State: Active, Not in Use, EULA not accepted
License Priority: None
License Count: Non-Counted
Index 2 Feature: ipbase
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Priority: Medium
License Count: Non-Counted
Index 3 Feature: lanbase
Period left: Life time
License Type: Permanent
License State: Active, Not in Use
License Priority: Medium
License Count: Non-Counted
HOSTKJ1#sh version
License Level: ipbase
License Type: Permanent
Next reload license Level: ipbase
I only have a license IP base
how to proceed in order to obtain one ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: