ip policy route-map on 3750

[sebastien.fr]

Hi,

I try to enter the command "ip policy route-map"  on 3750's interface. But the command doesn't appear.

Why? Whereas I see several times that this command is possible on this switch.

What I have to do to enter this command?

Thanks!

[Jon Marshall]

Sebastien

To run PBR on the 3750 you need -

1) to be using the IP services image and not the IP Base image

2) you need to run the routing sdm template ie.

3750# sh sdm prefer

will show you the current template

3750(config)# sdm prefer routing

will enable the routing template.

Note that a change in the sdm template requires a reload of the switch.

Jon

[sebastien.fr]

How to activate the "Ip services image" instead of "Ip base image"?

Because I just have activated PBM like you wrote it and the command "ip policy route-map" still doesn't appear.

I use the IOS 12.2(35) version.

[sapetrola]

Excellent! It worked this way for me. Thanks a lot.

[FABIO BETTINI]

Hi John,

I have the same problem Sebastian has, and I have a cisco catalyst WS-C3750G-24PS stack with four switches.

I'm using C3750 Software (C3750-IPSERVICESK9-M), Version 12.2(55)SE8.

I also inserted the command you described about to prever SDM routing profile exactely as you described but I'm still unable to insert the command ip policy router-map statement on the virtual inteface.

What I'm doing wrong ?

Thank's a lot for yoour further suggestions

Fabio