Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP/Port Binding for RV042 Dual Wan Router

Dear All,

   The RV042 route work fine with the pppoe (WAN1) connection with all internet stuff. Now we tried to config WAN2
to serve smtp, pop3 and some others web services under our network area.
   We config a static ip, gateway, dns to WAN2, set "Load Balance" and add related "Protocol Binding" at
"System Management"-> "Dual Wan" tag. After saved and enable those config, client pc's still use WAN1 to
connect to those services. Seem the RV042 can connect to the WAN2 gateway as no error log at "Log" tag.

   The firmware of the RV042 is 1.3.12.19-tm (Feb 13 2009), which seem the most update one
from http://www.cisco.com/en/US/products/ps9925/index.html.

   Anyone had idea on this? Thank for helping.

1108
Views
0
Helpful
0
Replies