Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ip protocol and osi model

I don't know where is ip protocol and where should locate in osi model ( infact in encapsulation the packet in which layer )

plz help

1 REPLY
Cisco Employee

Re: ip protocol and osi model

Hello,

The IP header is a Layer 3 header where you will specify the

source/destination IP addresses. You will also specify the upper layer

protocol that the network layer should communicate with for that specific

packet. This information is embedded in the packet using "protocol" field.

In the layer 4 header (TCP/UDP), you will specify the port information.

http://www.tcpipguide.com/free/t_IPDatagramGeneralFormat.htm

There are lot of layer 4 protocols that are not dependent upon the TCP/UDP

stacks. They directly interact with the IP layer and have their own way of

encapsulating the packet.

Essentially, you can look at entire TCP/IP stack as a way of packaging data

within a packet.

Hope this helps.

Regards,

NT

234
Views
0
Helpful
1
Replies
CreatePlease to create content