Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip service reflect

I have 2 systems in different locations sending to the multicast address 239.192.201.19 on port 55304 - I have been tasked with sending both of these feeds into another system for analysis.  So immediately you can see the problem.

 

After some googleing, I discovered the virtual interface (interface vif 1) and within it, the 'ip service reflect' command to re-address multicast destination addresses.  Perfect!

So, I configured it as such:

 

interface GigabitEthernet0/0
 description CAT11 in
 ip address 192.168.104.220 255.255.255.0
 ip pim sparse-dense-mode
 duplex auto
 speed auto
!
interface Vif1
 ip address 10.10.10.1 255.255.255.248
 ip pim sparse-dense-mode
 ip service reflect GigabitEthernet0/0 destination 239.192.201.19 to 239.192.211.19 mask-len 32 source 10.10.10.2
 ip igmp static-group 239.192.201.19
!

Connect the router to a switch and subscribe to 239.192.211.19 port 55304 - works a treat...on my test system!

When I add it to the production environment, the data is not available.  The production switch has a 'trunk' configured, which carries the same multicast data from the other system (with the original multicast address entact (239.192.201.19:55304)) as well as another multicast data stream from a totally different address and port.

The switch connecting to (what I call the multicast re-addressing router) is configured as 'no switchport' and an IP address on the same subnet as the re-addressing router.  'ip pim sparse-dense-mode' is also configured on the switch interface to the router and vice versa.

The Router (both production and test) are ISR 2911 running 15.3(3)M and ipbasek9 licence along with securityk9, datak9, uck9 and many more enabled.

The switches are 3750G running 12.2(44)SE5 using the IPSERVICESK9-mz image.  All commands (such as ip multicast-routing distributed, ip pim sparse-dense-mode, ip igmp join-group) all work, so it's not a case of licence/image issues.

Any ideas would be greatly appreciated.

 

The other 2 multicast streams work correctly as well - can subscribe to the multicast groups and receive data.

 

Everyone's tags (1)
316
Views
0
Helpful
0
Replies