Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP SLA Config

Hi,

     Has anyone of you implemented IP SLA for dynamic failover? How does this work? do you have any guides on how to implement this.

     Thanks.

1 REPLY

Re: IP SLA Config

Hi,

Ya, I have configured IP SLA in our network to track the remote ip reacahbility .

If the primary remote link is down, the failoever will happen automatically.

Example :

If you have 2 link to your ISP and if the primary link is down and the traffic has to divert to secondary automatically,then you can use IP SLA to track the primary link.

After that apply this configuration into your inside HSRP config.if primary link is down, then the track will reduce the HSRP priority value from 110 to 80.

Since the default HSRP value 100 is configured in secondary router, all the traffic will go via secondary link and there will be no impact.

Router 1 :

ip sla monitor 1

!

type echo protocol ipIcmpEcho  source-ipaddr 
 frequency 300
!
ip sla monitor schedule 1 life forever start-time now

rtr 1 track 1 reachability


int xxxx
ip address 1.1.1.2 255.255.255.0
standby 2 ip 1.1.1.1
standby 2 priority 110
standby 2 track 1 decrement 30
standby 2 preempt


Router 2:

int xxxx
ip address 1.1.1.3 255.255.255.0
standby 2 ip 1.1.1.1
standby 2 preempt

Regards
Karuppu



607
Views
0
Helpful
1
Replies
CreatePlease to create content