I need to configure an IP SLA based on % BW utilization.
Can any oe help me how can I do?
The Aim is : Traffic is flowing from both DS3 links when both DS3 links are up. When my one of the DS3 link will down than the traffic on one DS3 link will be very high. In this case I need to transfer some of the traffic on MPLS link till the down DS3 link will be up. In other way I can say when my one avaialbe DS3 link get 90% utilized than the rest of the traffic should move from MPLS link.
OER/PFR option is not suitable in My case.
Can you please help to take the decesion based on the IP SLA tracking or any other way.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...