Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Community Member

ip summary-address rip Not working in Cisco packet Tracer

Hello I am trying to config router(1941 or 2811) with RIP summary address

But its showing me error in syntax

 

Just created new router object and typing

interface Serial0/1/0
ip add 172.16.1.1 255.255.255.0
ip summary-address rip 172.16.1.0 255.255.255.252

Снимок.PNG

 

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: ip summary-address rip Not working in Cisco packet Tracer

well then its not supported only eigrp is for summary addresses , does it even let you in general configure RIP in global config ..router rip  , its supported on real routers , there virtual so there stripped down images

 

You could do it in GNS3 as that uses full Cisco IOS images with all features available

4 REPLIES
VIP Purple

Re: ip summary-address rip Not working in Cisco packet Tracer

whats options does it give you after ip summary-address use the ?
Community Member

Re: ip summary-address rip Not working in Cisco packet Tracer

Only egrp

VIP Purple

Re: ip summary-address rip Not working in Cisco packet Tracer

well then its not supported only eigrp is for summary addresses , does it even let you in general configure RIP in global config ..router rip  , its supported on real routers , there virtual so there stripped down images

 

You could do it in GNS3 as that uses full Cisco IOS images with all features available

VIP Purple

Re: ip summary-address rip Not working in Cisco packet Tracer

Hello 

agree with Mark it does work in gns3  simulations - just verified it

 

Res

paul

 

Please don't forget to rate any posts that have been helpful.

Thanks.
405
Views
0
Helpful
4
Replies
CreatePlease to create content