04-05-2010 08:36 PM - edited 03-06-2019 10:28 AM
Hello, I was wondering if anyone could point me to some examples of using IPv6 with DHCP in a campus environment? I have looked around the Internet for lab examples on this and have only come up with syntax examples. I plan on setting up just a small environment, probably only 1 router connected to 1 host just to experiment with dynamic IPv6 address allocation and I was wondering how to do this. Thank you for your help!
-Dan
Solved! Go to Solution.
04-05-2010 11:08 PM
Hello, I was wondering if anyone could point me to some examples of using IPv6 with DHCP in a campus environment? I have looked around the Internet for lab examples on this and have only come up with syntax examples. I plan on setting up just a small environment, probably only 1 router connected to 1 host just to experiment with dynamic IPv6 address allocation and I was wondering how to do this. Thank you for your help!
-Dan
Hi Dan,
Check out the below link hope that helps
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-dhcp.html
Ganesh.H
Remember to rate the helpful post
04-05-2010 11:08 PM
Hello, I was wondering if anyone could point me to some examples of using IPv6 with DHCP in a campus environment? I have looked around the Internet for lab examples on this and have only come up with syntax examples. I plan on setting up just a small environment, probably only 1 router connected to 1 host just to experiment with dynamic IPv6 address allocation and I was wondering how to do this. Thank you for your help!
-Dan
Hi Dan,
Check out the below link hope that helps
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-dhcp.html
Ganesh.H
Remember to rate the helpful post
04-06-2010 06:53 AM
That should work out just fine! Do you know of any other resources? I appreciate the help!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide