Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ipv6 dhcp relay source-interface not available

Hi,

i am running IOS 15.2(4)M2 on a 2901

but i cannot put command ipv6 dhcp relay source-interface

although the command is on the config guide.

anyone know why or have the same problem?

thank you

1 REPLY
Green

ipv6 dhcp relay source-interface not available

Ivan,

Does this restriction affect you

http://www.cisco.com/en/US/docs/ios-xml/ios/ipaddr_dhcp/configuration/15-s/ip6-dhcp-srce-relay.html

Restrictions for Configuring a DHCPv6 Relay Source

  • If the configured interface is shut down, or if all of its IPv6 addresses are removed, the relay will revert to its standard behavior.
  • The command line interface (CLI) will report an error if the user attempts to specify an interface that has no IPv6 addresses configured.
  • The interface configuration takes precedence over the global configuration if both have been configured.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
147
Views
0
Helpful
1
Replies