Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ipv6 implementation

Hi,

What are the prerequisites and necessary conditions that are required to implement an ipv6 based lan setup. I have a 4506, 3560 and a 5500asa firewall, the 2 switches are connected onto the inside zone of the firewall and need to work on ipv6.

Likewise, Do you have any documentation on ipv6 based subnetting.

Regards,

uzair.

1 REPLY
Hall of Fame Super Silver

Re: ipv6 implementation

Hello Uzair,

you should be fine with your LAN switches

however, for C4500 the features supported depend from what supervisor is installed and from IOS image

for C3560 see

http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst3560/software/release/12.2_46_se/configuration/guide/swipv6.html

you need advanced ip services image

a link to IPv6 tech page

http://www.cisco.com/en/US/tech/tk872/tk373/tsd_technology_support_sub-protocol_home.html

and to config page

http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-addrg_bsc_con.html

where addressing is explained

and ASA chapter about ipv6

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/route_ipv6_neighbor.html

Hope to help

Giuseppe

143
Views
0
Helpful
1
Replies