I am experimenting with IPv6 at home, where I have a 877 router. I have successfully set up a 6to4 tunnel and am able to use it fully at the ethernet interfaces.
However, when I try to configure IPv6 on the wireless side I find out there is not ipv6 under the 'interface dot11radio 0'. There is not ipv6 available on BVIs when the wireless is part of it, but when I remove the wireless i can enable IPv6 on the BVI.
I am starting to think IPv6 is in no way supported on the wireless interface of the 877. When looking at the IPv6 Solutions white paper I see the 800 series is listed with a 'Now' in the 'IPv6 Status', and no mention of it in the release notes means to me I should be able to configure it.
Of course, there might be some 'hidden' command that I am unable to find which enables IPv6 on wireless interfaces.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...