Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

IPv6 ospf passive interfaces sending hellos?

I have a Catalyst 3560G running 15.0(1)SE IP Services.  I have IPv6 enabled via the sdm and have configured IPv6 OSPF.

With IPv4 OSPF we typically make all user VLANs passive interfaces and uplinks point-to-point.  Usually with the 'passive-interface default' and no passive-interface gigabitethernet x/x' commands.  I have now enabled IPv6 OSPF with the global commands and interface commands below:

ipv6 router ospf 10

auto-cost reference-bandwidth 10000

passive-interface default

no passive-interface Vlan99

ipv6 router ospf 10

auto-cost reference-bandwidth 10000

passive-interface default

no passive-interface Vlan99

!

interface vlan99

ipv6 ospf 10 area 0

ipv6 ospf network point-to-point

!

interface vlan10

ipv6 ospf 10 area 0

!

With this configuration I am seeing IPv6 OSPF hellos on vlan 10, which I am pretty sure I shouldn't as it is passive.  I have checked all the ipv6 ospf interface commands and can't see one that turns the interface passive.

Am I missing something or is this a bug?

Andy

1 REPLY

Re: IPv6 ospf passive interfaces sending hellos?

Sorry my mistake...  Just realised the Guest VLAN isn't passive and I am monitoring on an 802.1x port that has an IP phone attached without a PC piggy-backed....

There is no delete question button....

Andy

993
Views
0
Helpful
1
Replies
CreatePlease to create content