Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ipv6 unicast-routing not available

Hi folks,

I'm facing the following problem on a cisco WS-C3750G-24TS vith the following configuration :

IOS : Version 12.2(35)SE5

System image : c3750-ipservices-mz.122-35.SE5

I configured the C3750 with "sdm prefer dual-ipv4-and-ipv6 routing" and made a reload.

I can now configure ipv6 addresses on interfaces, create IPv6 ACLs, set up static routes, etc. but I can't turn the switch to an IPv6 router because the command "ipv6 unicast-routing" is not available.

What's wrong with the configuration ?

Thanks a lot in advance.

Roland.

5 REPLIES
Cisco Employee

Re: ipv6 unicast-routing not available

Roland,

You need Advanced IP Services to enable IPv6 unicast routing on the 3750.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
Community Member

Re: ipv6 unicast-routing not available

I've run into the same problem in a 3650 and was struggling to find a solution. I've compared the "ip services" with the "advanced ip services" image at cisco's feature navigator. Although the first one has a bunch of ipv6 features, the second one has only the following 4 features additional to the first one:

CEFv6/dCEFv6 - Cisco Express Forwarding

IPv6 Neighbor Discovery Throttling

IPv6 Routing: OSPF for IPv6 (OSPFv3)

IPv6 Switching: CEF/dCEF Support

I can't figure out which of these 4 includes the "ipv6 unicast routing" feature. What do I miss?

Hall of Fame Super Silver

Re: ipv6 unicast-routing not available

Hello Kostas,

it is a question of implementation:

a multilayer switch needs to be able to perform switching in hardware or it is better for it to not be able at all to route ipv6 packets.

so the key item here is IPv6 Switching: CEF/dCEF Support

Hope to help

Giuseppe

Community Member

Re: ipv6 unicast-routing not available

Hi Harold  I am trying to install ipv6 

ipv6 unicast-routing

Invalid input detected at '^' marker

Cisco IOS Software, 3800 Software (C3845-ADVSECURITYK9-M), Version 15.1(4)M8,

Can you help me.

Thank you,

Community Member

Re: ipv6 unicast-routing not available

This thread is 8 years old by the way.

But regardless, he clearly says it in his post.

"You need Advanced IP Services to enable IPv6 unicast routing"

You have advsecurityk9 not advipservicesk9 (or adventerprisek9)

1110
Views
0
Helpful
5
Replies
CreatePlease to create content