I think I already know the answer to this, but need to ask.
I have 2 3560 48PS switches I need to do IPX switching on. Current software is 12.2.SEB4, IP Services. Older versions of the IOS have all been defered (I was looking for an EMI version).
My question is, does anyone out there know of a way to do layer 3 IPX routing to this router. I would like to avoid doing layer two to the switch, as it would be coming back into my core. We do have people using the Novell client, so IP only is out of the question (sadly).
Basically, the Cat3560 only supports IP routing and does not support IPX nor Appletalk. To get packets to switch across vlans, we must use a feature called Fallback Bridging. You must have an EMI image instead of an SMI.
For more info about Fallback Bridging,please visit this URL:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...