That's the first suggestion I would have. Make sure that the link is becoming active as soon as possible on the ports where both the server and the client are connected. Use the port host macro if necessary (it disables trunking and DTP at the same time it enables portfast). IPX client are immediately trying to connect to their server and need immediate availability of the L2 network. If this does not help (and you can of course confirm connectivity using some other device for instance), it's not likely to be a network issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...