Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPX VLAN on 6509s multiple clients environment (VRFs)

Hi everybody

Please see the attached diagram. It's a multienvironment client, the two VRF's belong to the same client. I need to create an IPX VLAN on the two Catalysts and terminate the tunnel as depicted in the diagram on a router connected to the two VRFs. I am being told that it is not safe or recommended to create the IPX VLAN there. What whould be the pros and cos for this. Are you aware of any special L2 settings that I have to use for this VLAN ? I do not intend to use the Catalysts to route IPX traffic. The router will do it.

Thank you

Cristian

2 REPLIES
Bronze

Re: IPX VLAN on 6509s multiple clients environment (VRFs)

As you want only to have IPX vlans, you need to configure the IPX network numbers under the vlan interface config mode.

Router(config)# interface

Router(config-if)# ipx network [ | unnumbered] encapsulation

New Member

Re: IPX VLAN on 6509s multiple clients environment (VRFs)

As mentioned above the IPX routing will be handled by the Cisco router not by the Catalys L3 Switches

Thank you

Cristian

141
Views
0
Helpful
2
Replies