the BVI number points to the bridge-group number and so they must match in a working configuration
in other words: there is no explicit command to associate a BVI to a bridge-group so the match is required
It is the same like in a multilayer switch with SVIs: the L3 interface vlan X refers to broadcast domain vlan X ( L2 concept)
in IRB the BVI plays the role of SVI in a multilayer switch it provides L3 services you couldn't route without IRB, you are bridging IPv4 within bridge-group 1 interfaces and you can route IPv4 from bridge-group 1 to/from other L3 interfaces via the associated BVI.
I wonder about the native Vlan; in my case vlan 6--- [F0/0.6 encapsulation dot1q 6 native]. I wonder if there is a vlan/STP mismatch that causes STP (ieee) to become a broadcast like when you connect Cisco switches to non-Cisco switches?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.