I just turned up a 1 gig ethernet fiber connection across our state - a distance of 250 miles. Each end is terminated on a 7604 with Sup720-3B and 7600-SIP-400. The carrier says this connection goes through 2 OC48s.
With nothing loading down this new link, there is an 8ms RTT when doing pings.
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 220.127.116.11, timeout is 2 seconds:
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/8 ms
Is this acceptible? 8ms seems high for a gig fiber link
Its probably ok , you have to remember that a router puts ping at the low end of the priority poll and it will always look longer than it is , to get a more accurate picture ping thru the router on the far end to a known device other than the router.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...