Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is static NAT only way for DVR/Servers access?

Are static NAT the only way for allowing access to DVR/Server?

I have around 8 DVRs/Servers all in different networks, so 16 command lines for static NAT both ways.

Example:

For 1 DVR access-

ip nat inside source static 10.10.x.x 50.x.x.x

ip nat outside source static 50.x.x.x 10.10.x.x

Please let me know if there is a easier way to do it. The problem is I cant do dynamic as they all are in different locations (networks).

1 ACCEPTED SOLUTION

Accepted Solutions

Is static NAT only way for DVR/Servers access?

Are you wanting access from the outside of the network? If so, you only need the "ip nat inside" line.

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
1 REPLY

Is static NAT only way for DVR/Servers access?

Are you wanting access from the outside of the network? If so, you only need the "ip nat inside" line.

HTH,
John

*** Please rate all useful posts ***

HTH, John *** Please rate all useful posts ***
167
Views
0
Helpful
1
Replies