Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

is there a way to modify the flap-values on err-disable?

Does anyone know if that is possible to change

ErrDisable Reason Flaps Time (sec)

----------------- ------ ----------

pagp-flap 3 30

dtp-flap 3 30

link-flap 5 10

.. the link-flap to let's say 3 flaps within 20 seconds?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: is there a way to modify the flap-values on err-disable?

Rack1SW4(config)#errdisable flap-setting cause link-flap max-flaps 3 time 20

Rack1SW4#sh errdisable flap-values

ErrDisable Reason Flaps Time (sec)

----------------- ------ ----------

pagp-flap 2 60

dtp-flap 3 30

link-flap 3 20

Regards,

Edison.

4 REPLIES
Hall of Fame Super Bronze

Re: is there a way to modify the flap-values on err-disable?

Rack1SW4(config)#errdisable flap-setting cause link-flap max-flaps 3 time 20

Rack1SW4#sh errdisable flap-values

ErrDisable Reason Flaps Time (sec)

----------------- ------ ----------

pagp-flap 2 60

dtp-flap 3 30

link-flap 3 20

Regards,

Edison.

Cisco Employee

Re: is there a way to modify the flap-values on err-disable?

Hello Edison,

Thanks very much for your hint. How come that this command is not documented at all? I have had a look on various versions of IOS Command References for 3560 series switches and while the command is indeed available in the IOS, it was not described in the documentation.

Best regards,

Peter

Hall of Fame Super Bronze

Re: is there a way to modify the flap-values on err-disable?

Community Member

Re: is there a way to modify the flap-values on err-disable?

Thank you, That's exactly what I was looking for.

384
Views
5
Helpful
4
Replies
CreatePlease to create content