"Note: When you have a WiSM installed on a switch that runs Cisco IOS Software Release 12.2.33SXI, defining a Port-Channel manually on the switch and applying it to the gigabit interfaces does not work. Auto-lag must be used."
this forces me to use the "wism module <slot> controller <1 or 2> " to configure the channel.
How do we do advanced port configurations like "mls qos" and "wrr-queue..." commands on these channels or the physical ports?
Is there a way with this release of IOS to not do automatic LAG?
Re: Is there any way to make a WISM Service module to not do Aut
>>the internal port-channels towards the two processors of the WISM will be LACP, no other way as far as I know.
Thats not what I was asking. I know that the WISM requires etherchannel with no way to turn it off like on a 4404. I am not trying to do that.
In versions of IOS prior to 12.2.33SXI, we created port channels manually to the WISM the same way you would on a ethernet line card module.
After 12.2.33SXI, you MUST use the supervisor "auto-LAG" feature which automatically creates the port channel with a seemingly random port channel number. All configuration to the port channel and the underlying GigE ports are done by the "wism" command on the supervisor.
I am hoping (perhaps in vain) that we can get the flexibility we had in older versions of 6k IOS.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.