I have 3 routers connected to a switch, see diagram attached.
R1 is set as the default gateway for R2 and R3, R2 and R3 has the same static routing configuration âip route 0.0.0.0 0.0.0.0 next hop on R1â. R3 can now ping R1 interface connected to the switch, but R2 can't ping R1.
R2 can ping the switch, vice versa. And the switch can ping R1, vice versa. I was wondering if there's problem with the switch, as I can't find any problems. These are very simple configurations which I have done a few times successfully in the past. Thanks.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...