Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Is this command security authentication failure rate 3 log?

Availabe in IOS 12.2 (55r).SE7?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Green

Is this command security authentication failure rate 3 log?

Steven,

This command did NOT come in play till 12.3.1

Command History

Release

Modification

12.3(1)

This command was introduced.

12.2(27)SBC

This command was integrated into Cisco IOS Release 12.2(27)SBC.

12.3(7)T

The range of the threshold-rate value was changed from 1 through 1024 to 2 through 1024.

Usage Guidelines

The security authentication failure rate command provides enhanced security access to the router by generating syslog messages after the number of unsuccessful login attempts exceeds the configured threshold rate. This command ensures that there are not any continuous failures to access the router.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
3 REPLIES
Green

Is this command security authentication failure rate 3 log?

Steven,

This command did NOT come in play till 12.3.1

Command History

Release

Modification

12.3(1)

This command was introduced.

12.2(27)SBC

This command was integrated into Cisco IOS Release 12.2(27)SBC.

12.3(7)T

The range of the threshold-rate value was changed from 1 through 1024 to 2 through 1024.

Usage Guidelines

The security authentication failure rate command provides enhanced security access to the router by generating syslog messages after the number of unsuccessful login attempts exceeds the configured threshold rate. This command ensures that there are not any continuous failures to access the router.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
New Member

Is this command security authentication failure rate 3 log?

Hi Alex,

Thanks!

Cisco Employee

Hi I wanna know if this

Hi I wanna know if this command is supported on IOS - XE i tried 3.6.0 as well but it was not supported . Can u help me on pointers for this command in ios-xe or similar equivalent commands on the platform

1508
Views
0
Helpful
3
Replies
CreatePlease to create content