Isolate VLANs (1 for public, 1 for Private) - using WAP

[ocarmona777]

Need the following objectives:

Need 1 WAP Cisco 1130 to have 2 SSID's and each one it's own separate VLAN.

- Vlan 18 is going to for employess

- Vlan 19 is going to be "public" it will only have access to Internet

I have 1 vlan for internet which is Vlan 154

I have Vlan 100 is for the servers

- Vlan 18 should comunicate with both of them.

- Vlan 19 should only communicate with the internet Vlan, 154 but should also get a DHCP address from the server wich is 192.168.100.200

I have a Cisco 3560 Switch.

Help! How to isolate the VLan?

[manojr2005]

is you 3560 a layer 3 syitch ? if yes then for the guest Vlan provide the ip helper address 192.168.100.200, create a ACL deny any any , then create acl Permit any host 192.168.100.200, this is to communicate with this server to get the DHCP. asign this Access group to the vlan 100 as in bound.