ISP failover using IP SLA???

[Janardhan Meesala]

HI,

I am trying to configure ISP failover using IP SLA tracking in Cisco 3900 router(C3900-SPE100/K9).

I want to configure below commands:

R1(config)# ip sla 1

R1(config)# icmp-echo 2.2.2.2 source-interface FastEthernet0/0

R1(config)# timeout 1000

R1(config)# threshold 2

R1(config)# frequency 3

R1(config)# ip sla schedule 1 life forever start-time now

But the problem is i seen only below commands in the router:

Router(config)#ip sla ?

  key-chain  Use MD5 Authentication for IP SLAs Control Messages

  responder  Enable IP SLAs Responder

  server     IPPM server configuration

Please help me to configure IP sla static route tracking in Cisco 3900 series router.

Regards,

Janardhna

[The_guroo_2]

Hi

Its not recommended to use IP SLA for thi pupose (though in IT you can do anything) can you xplainyour network in brief and i will give you better option...Are yo using any routing protocol with you ISP...tell me more abt it

Thanks

[Janardhan Meesala]

Hi,

It is simple. I have one router and my two ISP connections are terminated in my Cisco 3900 router. I have two static default routes points to the gateways of respective ISPs.

Just here i like to configure ISP failover using ISP SLA tracking. I am not seen any commands on this Router.

Please help me to solve this issue.

Regards,

Janardhan

[JohnTylerPearce]

What IOS version do you have? Also, could you be running AAA on this router and not have sufficent access for these commands? This can also happen if someone has set you up with a privilege level.