Intiallay ISP commited to provide link connectivty for over 6 sites on seperate access ports but than they are providing on a single trunk link with different vlan id for each site. I need to terminate it on 3560 (as WAN routing device)that would connect to Core switch 3750 and in turn connect to LAN access swiches.
As per my understanding i cannot make subinterfaces on 3560. I am really confused how to terminate it on 3560 ?
Yes i do understand that on one side of 3560 i need trunk. For SVI, can u elaborate how routing will work. on remote sites we have routers and we intend to run OSPF on it. Also the provider is throwing internet on same trunk,
Packet goes from HeadOffice to branch
1 -a user on access layer send packet to access switch.
2- Access Switch will send it to core (3750) using default route.
3- Core(3750) running ospf know next hop is 3560 WAN Aggregation Switch.
4- Now on 3560 how routing will send packet to internet and branches???
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.