Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISR 1841 > config vlan & trunk

Hello

Could somebody help me?

I'm having difficulties while configuring vlan and dot1q trunking on a modular 1841 router.

IOS c1841-spservicesk9-mz.124-2.XA.bin is installed on the router and according to the Cisco Software Advisor there is dot1q and vlan support.

This is the output:

router#vlan database

router(vlan)#show

VLAN ISL Id: 10

Name: VLAN0010

etc.

router#show vlans

No Virtual LANs configured.

router#show vlan-switch

VLAN Name Status Ports

---- -------------------------------- --------- -------------------------------

1 default active

10 VLAN0010 active

1002 fddi-default active

1003 token-ring-default active

1004 fddinet-default active

1005 trnet-default active

VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2

---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------

1 enet 100001 1500 - - - - - 1002 1003

10 enet 100010 1500 - -

I've read that I need to use next command "Router(vlan)# vlan 10 media ethernet name VLAN0010" to add a port to a vlan.

All these commands are not helpfull or am I doing something wrong.

Switchport commands don't work and apparently only dot1q tunneling is supported.

So is this a command problem or is it better to use a newer image?

Thanks for the help

343
Views
0
Helpful
0
Replies