Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Issue for inside LAN translation with CISCO 861 / RV042

Hello,

I have to connect two sites using VPN Tunnel. For that I have on one side a RV042 router and on the other side a CISCO 861. In addition to the VPN connection, I have also to translate IP addresses from one site.

On site A:

LAN: 192.168.10.0 /24

On site B

LAN 10.1.10.0/24

For the site B the LAN of site A must be 10.1.20.0/24. But I cannot change computer IP. So I need to translate (NAT) site A LAN from 192.168.10.0 to 10.1.20.0 network.

It seems that the RV042 router cannot NAT lan through VPN. Based on equipment feature I buy a CISCO 861 router. But I don’t found how to configure the inside LAN to LAN nat.

Thank you for your help.

Regards.

Everyone's tags (4)
2 REPLIES
New Member

Issue for inside LAN translation with CISCO 861 / RV042

Hi,

To translate 192.168.10.0/24 to  10.1.20.0/24 the following configuration can help.

Site A

int fa0/0

ip nat inside

int ser0/0

ip nat outside

access-list 111 permit ip 192.168.10.0  0.0.0.255  any

ip nat pool TRANSLATION  10.1.20.1 10.1.20.254 netmask  255.255.255.0

ip nat inside source list 111 pool TRANSLATION

Verfication:

Show ip nat translation

Show ip nat statistics

Issue for inside LAN translation with CISCO 861 / RV042

Hi Laurent,

What you need is policy based static-nat which will carry your natted subnet over IPSec tunnel.

Please follow the link, which explians step by step method of setting static-nat for IPsec tunnel.

http://www.booches.nl/2009/01/policy-nat-on-cisco-router/

Hope that helps.

thanks

Rizwan Rafeek

469
Views
0
Helpful
2
Replies