I have a router running 15.1 and have two VLANs defined (I have an NM-16ESW, so they are defined using the 'vlan' command). Everything works great and I can set the swithports to access or trunk etc.
I then bridged the VLAN1 and a gigabitethernet routable port using a BVI1 interface. In pseudo config:
no ip address
ip address 10.1.1.1 255.255.255.0
no ip address
ip address 192.168.2.1
bridge 1 protocol ieee
bridge 1 route ip
...now VLAN2 is no longer accesible from the switchports, and in fact appears not to exist on the router. For example I configure a switch port as switchport access vlan 2 and I get an error that VLAN 2 does not exist.
How do I tie my switch and routable port togther and include the VLANS?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...