Hi everyone. Hopefully somebody can shed light to this issue we are facing. We are connecting a Dell PowerEdge M620 to a Cisco 6509 core switch via a WS-X6716 10gig fiber module. A few minutes to an hour after connecting it, our entire network goes down. We don't see anything on the logs from the 6509 and we always end up disconnecting it. We have opened a case with cisco TAC already but I would also want to get some opinion from the good people of this forum. TIA.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...