Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Issue with HWIC-4ESW in Cisco 2821

I have a Cisco 2821 running Version 12.4(3b)

We inserted the HWIC-4ESW and copied the config over from an identical router (same model, same card type, etc.).  I'm not seeing the ethernet ports though!  when i do a "show ip int br" all I can see is the two gig ports.  I've tried reseating the card and reloading a few times.  When I do a show inventory, I see the card listed.  Help!

2 REPLIES
Purple

Re: Issue with HWIC-4ESW in Cisco 2821

  Do they show up when you issue "show int status "  ?    Wouldn't think it would need T train. these switchcards have been around since the 12.2T era  so all the functionality  should be in any later mainline versions.

Hall of Fame Super Gold

Issue with HWIC-4ESW in Cisco 2821

I have a Cisco 2821 running Version 12.4(3b)

Are you running the "T" train?  If you are unsure, please post the output to the following command:

1.  sh version; and

2.  sh log

261
Views
0
Helpful
2
Replies
CreatePlease to create content