As the subject indicates, I am trying to add a new 2960X switch to an existing 2960S stack.
There are two switches in the existing stack, running in a non-redundant mode.
I have upgraded the software of the 2960S to 15.0(2a)SE9, as this matches the major version of available software for the 2960X, 15.0(2a)EX5. I know that 15.2 is available for the 2960X, but I understood that the switches needed to be at the same major version.
I set the priority of the existing switches to be high - the master at 14, and the other existing member at 13.
I have added the FlexStack module to the 2960X, connected the stacking cables together, and powered on the new switch, and after a considerable amount of time (~30+ minutes), the 2960X does not show as a member of the CLI.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.