Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Jumbo Frame config help on 4506

Hello.. I have a 4506 with a SUPIII card and a WS-X4448-GB card. I want to enable jumbo frames for a iscsi connection. When I go into the interface that I want to enable jumbo frames on I issue the command:

mtu 9192. I then get the error "% Interface GigabitEthernet2/48 does not support user settable mtu."

Does anyone know how I can get around this?

Thanks!

James

1 REPLY
Hall of Fame Super Blue

Re: Jumbo Frame config help on 4506

James

As far as i know you can't because this module does not support jumbo frames. See this link for list of modules that do -

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configuration/guide/sw_int.html#wp1068699

Jon

1431
Views
5
Helpful
1
Replies