Got couple questions regards to jumbo fame in the 6509.I setup jumbo frame mtu in couple of interfaces on 6509.
1.I had WS-X6748-GE-TX in 6509.When I go to interface config mode.I can only configured as 9216 and nothing else.I was thinking to set it up as 9000 since our server support upto 9000.
<9216-9216>MTU size in bytes
2.After configured interface with mtu 9216 and server to max mtu 9000, I am able to ping between the hosts with
Ping 192.168.1.1 –l 8972 –f which is good news. So I cleared the counter and run show interface gi4/1 again, the count in “giants” start went up.My question: is the giants counter in show interface a jumbo frame been transmitted or it’s a error giants frame that been drop by interface?
Thanks for reading the post and any comments are appreciated.
Thanks for promptly reply. The bug is fixed in 12.2(18)SXF11 but I am running 12.2(33)SXH6.. Also do you know why I can only use 9216 in interface config mode? Why I can't use as range such as <1500 - 9216> ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.