Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

jumbo frames on 10gb sfp+ uplink and cross-stack etherchannel

I have a pair of stacked 2960S with 24 gig ports each, 2 sfp+ 10gb ports (uplinks), 2 cross-stack etherchannels and 2 vlans.

so if i issue "system mtu jumbo 9198" command and reload i understand that all 48 gig ports in a stack will be enabled for jumbo frames,

but what about these 2 10gb sfp+ uplinks, cross stack ether-channels, vlans?

do i need to issue a separate mtu comand on the int level for 10gb uplinks?

btw, the cross-stack etherchannel is only between 1gb ports, not 10gb.

thanks

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: jumbo frames on 10gb sfp+ uplink and cross-stack etherchanne

Hello Gregory,

>> system mtu jumbo 9198

system means system wide, so it will apply to all interfaces regardless of their speed, higher end switches (C6500) allow to set MTU per interface, but it is not the case for these 2960

I would suggest to do the change during a maintanance window and to check the effects on the etherchannel.

Hope to help

Giuseppe

2 REPLIES
New Member

Re: jumbo frames on 10gb sfp+ uplink and cross-stack etherchanne

any ideas?

Hall of Fame Super Silver

Re: jumbo frames on 10gb sfp+ uplink and cross-stack etherchanne

Hello Gregory,

>> system mtu jumbo 9198

system means system wide, so it will apply to all interfaces regardless of their speed, higher end switches (C6500) allow to set MTU per interface, but it is not the case for these 2960

I would suggest to do the change during a maintanance window and to check the effects on the etherchannel.

Hope to help

Giuseppe

1800
Views
0
Helpful
2
Replies