Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Jumbo Frames on Vlan 1

We have a 3750-E and have enabled the MTU Jumbo frames command but are seeing issues with some machines not actually sending jumbo frames. Our SAN Vendor says that a 3750 cannot do Jumbo Frames on VLAN 1. Is this True? Is there a workaround?

1 REPLY
Hall of Fame Super Blue

Re: Jumbo Frames on Vlan 1

I'm not aware of any issues with vlan 1 in particular. Can your SAN vendor point to you to any specific documents that verify this ?.

Without wishing to state the obvious if vlan 1 cannot do this could you not reallocate the machines into a different vlan.

Before you did that though i would check with Cisco - TAC maybe.

Jon

263
Views
0
Helpful
1
Replies
CreatePlease to create content