All, I have a 3750 stacked switch with 2 or so svi interfaces. Vlan50 and Vlan204.
A device which is hardcoded as switchport access mode is on the 50 vlan. I can ping the device, which has an IP of 10.175.56.15 from its source vlan 50 ip of 10.175.56.1. When I try and ping 56.15 from another vlan svi say vlan204 10.175.204.254 I get no replies.
I can ping every other device on the 50 vlan from vlan 204 but that one device. The device in question is an NTP server from Spectracom.
Its odd that I can source it from the vlan50 int and receive a reply. This means to me that the NTP server does know how to route to its default GW of 10.175.56.1.
But why wouldnt it be able to be pinged from the 204 vlan?
Any help would be much appreciative.
I can telnet into the NTP server, however I dont have credentials, as the customer doesnt own that box.
10.0.0.0/8 is variably subnetted, 3 subnets, 2 masks C 10.106.215.192/29 is directly connected, Vlan300 C 10.175.56.0/24 is directly connected, Vlan50 C 10.106.204.0/24 is directly connected, Vlan204 S* 0.0.0.0/0 [1/0] via 10.106.215.193
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...