Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

L3 Switch Gig Interface Message.

hello all,

One of our cisco 4500 series L3 switch is not accepting "no switchport" comand on its Gig port. As of now the port is L2.

Giving below message after executing command "no switchport" on gig interface:-

Cisco_4507_Switch#no switchport

Command rejected: Not a convertible port.

++++++++++++++++

IoS version on the switch is :-

System image file is "bootflash:cat4000-i9k91s-mz.122-20.EWA4.bin"

cisco WS-C4507R (MPC8245) processor (revision 4) with 524288K bytes of memory

What could be the reason for the message ...how to overcome the problem..

Regards

4 REPLIES
Bronze

Re: L3 Switch Gig Interface Message.

Hi Jimmy.

What kind of Supervisor do you have?

Also, the snip you show looks like you're not in conf t mode - is that right?

HTH

Silver

Re: L3 Switch Gig Interface Message.

are you under interface mode?

from your prompt you are under the exec mode.

you must enter one interface then issue the command

switch#config t

switch(config)# interface gig 1/15

switch(config-if)#no switchport

New Member

Re: L3 Switch Gig Interface Message.

Hello freinds,

that was typo, Please find the correct configs.

Cisco_4507_Switch(config)#int gi4/4

Cisco_4507_Switch(config-if)#no switchport

Command rejected: Not a convertible port.

Cisco_4507_Switch#

Supervisor :-

Mod Ports Card Type Model

---+-----+--------------------------------------+--------------

1 2 1000BaseX (GBIC) Supervisor(standby) WS-X4516

2 2 1000BaseX (GBIC) Supervisor(active) WS-X4516

Hall of Fame Super Gold

Re: L3 Switch Gig Interface Message.

Depends if your supervisor card can do L3.

170
Views
0
Helpful
4
Replies