01-29-2010 02:46 PM - edited 03-06-2019 09:30 AM
I am working in a lab environment and I have created several vlan intefaces on my 3560 that I want to be protocol "up". I only have 1 router connected to it for 1 vlan only that is currently protocol up, is there a command that I can use to have all the other vlans protocol up, so I can ping them? Please advise.
thanks.
01-29-2010 02:59 PM
david-flores wrote:
I am working in a lab environment and I have created several vlan intefaces on my 3560 that I want to be protocol "up". I only have 1 router connected to it for 1 vlan only that is currently protocol up, is there a command that I can use to have all the other vlans protocol up, so I can ping them? Please advise.
thanks.
David
If you want the other vlan interfaces to be up/up and you have no devices to connect into the switch ports then the only way to do this would be to make the link between the 3560 and the router a trunk link and allow all the vlans on that trunk.
Jon
01-29-2010 03:02 PM
that what I figured. Thanks Jon. I was hoping there was some other trick using loopback interfaces, or tweaking the keep-alives.
thanks again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: