LACP across two 2960s

[groupedlsi]

Hello, does anybody know if I can setup a cross-stack LACP between two stacked C2960S-48TS-L(with the additional stack module) ?

If it is, is there any limit (ports or groups limits)?

Thanks a lot,

Ludovic

[glen.grant · Accepted solution]

  You should be able to do that .  On older 2960's they were limited  to  6 port channels per box , don't know if that has changed on the newer 2960's or not.

[Ankur Arora · Accepted solution]

Hi

Cross Stack LACP is possible.

However you still have there is a limitation to 6 port-channels.

Please go through the following link for details:

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_see/configuration/guide/swethchl.html#wp1275881

Thanks

Ankur

"Please rate if found useful"